A frayed or snapped lift cable throws the whole door off balance, and a door hanging crooked on one cable is a genuine safety hazard. We replace cables and inspect the drums they wind onto.
Matching wear on both cables means both get inspected and typically replaced together.
Cable replacement without a drum check is an incomplete repair, so we always look at both.
Lift cables connect directly to spring-loaded drums, so replacement requires the same careful tension handling as spring work.
Cable stock in standard gauges means most replacements happen in a single visit.
Whatever brought you here, one of these service lines is the fix, and one call gets a technician moving.
We replace the snapped cable and its pair, then verify even tension across both sides.
Catching a fraying cable early avoids the sudden, uneven drop that comes with a full snap.
A cable that's jumped its drum groove can jam the door mid-cycle. We reset it correctly and check for the underlying cause.
We match new drums to the correct diameter for your door's cable length requirements.
Correcting an uneven lean means addressing the cable, checking the spring pair, and confirming the track is still square.
A quick description of the lean or jam gets the right cable gauge loaded before arrival.
Technicians carry standard cable gauges and lengths for most residential doors.
Diagnosis includes the drums, not just the visible cable, before any price is confirmed.
We verify the door hangs and travels evenly before calling the repair complete.
“Cable kept jumping the drum every few cycles. Turned out the drum itself was cracked, replaced and fixed.”
“Caught the fraying cable during a routine call before it actually snapped. Appreciated the heads-up.”
“Door was jamming mid-cycle for weeks. Cable and drum issue, fixed in one visit.”
This almost always means one lift cable or spring has failed while the other side is still holding weight.
Both cables typically get replaced together to avoid a near-term repeat call.
We treat cable failures as priority calls given the safety risk involved.
We check the drum groove condition whenever a cable keeps coming off, since replacing just the cable won't fix a bad drum.
Pricing depends on cable length, gauge, and whether the drums also need replacing, confirmed as a flat number before work starts.
A snapped-cable call usually resolves in under two hours on-site.
Licensed technicians, flat-rate pricing, and a truck stocked for this exact job.
☎ Call +1-831-293-1591From one side of Marion to the other, dispatch is built to reach you quickly.
Embedded Map Placeholder for Marion, MS